ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
4. Install Jackscrews through the autosampler case and into the 37-pin
connector ears, threading and then fully tightening with a 3/16” nut
driver to securely attach daughter board to the chassis (Figure 1-25).
Figure 1-25
Jackscrews securing Daughter board (ASX-520).
Note:
Ensure that the Auxiliary I/O board pins are fully and correctly seated
into the main circuit board socket before installing and securing the
jackscrews as is outlined above.
35