ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
11. Remove stand-off with 1/4” nut driver and discard
(Figure 1-37). Remove the spacer located under the stand-off and
place with the other two spacers received with the installation kit.
Figure 1-37 Removal of stand-off (ASX-260).
12. Place a washer and then a spacer on the three mounting posts
(Figure 1-38).
Figure 1-38 Washers and spacers installed (ASX-260).
45