ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
8. The screws that hold the inner shield must be removed. Move the Y-
axis assembly all the way to the left (Figure 1-16/ Figure 1-17 shows
screw locations). Your autosampler may have a newer style shield
with splashguard. These are removed in a similar manner.
Figure 1-16 View of inner shield inside the ASX-520 Autosampler.
Figure 1-17 View of inner shield inside the ASX-260 Autosampler.
29