ASXpress Operator's Manual - CETAC Technologies

ASXpress Rapid Sample Introduction System Operator’s Manual
Chapter 3: Installing the Rapid Sample Introduction System
6. Insert Rabbit module processor (supplied in the upgrade kit) in the
same position/orientation as the removed unit had been installed.
Be sure to align all pins to the proper socket hole location, using care
to insert the module fully and securely.
Figure 1-27 Rabbit shown removed and placed to show pin
orientation (ASX-520/ASX-520HS).
Proceed to “Install the ASXPRESS Software” section of this manual
(do not replace covers, etc., at this time).
WARNING
When inserting or reinserting any connectors, such as the ribbon cable,
auxiliary board or rabbit module, make certain that they are properly
connected, ensuring that no pins are bent and all the pins are in their
proper position in the connector. Improper connections could result in
damage to the main board or other components.
37