DSLBD Office Fit Out - Broughton Construction Company
DSLBD Office Fit Out - Broughton Construction Company
DSLBD Office Fit Out - Broughton Construction Company
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
5. Samples shall represent, in all respects, minimum quality to be furnished by manufacturer. No<br />
work represented by samples shall be fabricated until samples are accepted. Downgrading of<br />
quality demonstrated by samples may be cause for rejection.<br />
6. Submit 2 samples for each wood finish; minimum.<br />
7. Sample Size:<br />
a. Wood Veneer Finishes:<br />
1) Transparent Finish: 18” min. width x 30” min. length<br />
2) Opaque Finish: 12” x 12”<br />
b. Solid Stock Trim: 12” lengths<br />
D. Quality Assurance Submittals:<br />
1. Test Reports:<br />
a. Submit test reports prepared by an independent testing laboratory indicating full<br />
compliance with specified requirements for screw withdrawal, split resistance, and hinge<br />
loading.<br />
2. Certificates:<br />
a. Door manufacturer shall provide a letter, signed by an authorized company<br />
representative, to Architect stating that doors have been manufactured in compliance<br />
with this specification.<br />
3. Manufacturer’s Instructions:<br />
a. Submit manufacturer’s installation procedures which shall be basis for accepting or<br />
rejecting actual installation procedures.<br />
1.05 QUALITY ASSURANCE<br />
A. Qualifications:<br />
1. Door manufacturer shall be a company with a minimum of 5 years of verifiable experience<br />
manufacturing wood doors.<br />
2. Wood doors shall be five-ply construction, seven-ply construction does not satisfy this specification<br />
and shall not be acceptable.<br />
3. Single Source Responsibility:<br />
a. To greatest extent possible, wood doors shall be products of a single manufacturer.<br />
b. Veneers for transparent finishes shall be supplied from a single source.<br />
c. Provide secondary materials that are produced or are specifically recommended by<br />
manufacturer of wood doors to ensure uniformity of quality and appearance throughout<br />
Project.<br />
B. Regulatory Requirements:<br />
1. Comply with applicable provisions and recommendations of AWI for materials, fabrication and<br />
machining of wood doors.<br />
2. Fabrication and installation of fire rated wood doors shall comply with ASTM E152 and National<br />
Fire Protection Association (NFPA), Underwriters Laboratories (UL), and Door and Hardware<br />
Institute (DHI) provisions or standards listed below.<br />
3. National Fire Protection Association:<br />
a. NFPA 80 Standard for Fire Doors and Windows<br />
b. NFPA 101 Life Safety Code<br />
c. NFPA 105 Recommended Practice for the Installation of Smoke-Control Door<br />
Assemblies<br />
d. NFPA 252 Standard Methods of Fire Tests of Door Assemblies<br />
4. Underwriters Laboratories Inc.:<br />
a. UL Standard 10C Fire Tests of Door Assemblies<br />
b. UL Standard 1784 Air Leakage Tests of Door Assemblies<br />
5. Door and Hardware Institute:<br />
a. WDHS-3 Recommended Hardware Locations for Wood Flush Doors<br />
6. Comply with applicable Federal Accessibility Regulations:<br />
WOOD DOORS 08 14 00-3
Change language