DSLBD Office Fit Out - Broughton Construction Company
DSLBD Office Fit Out - Broughton Construction Company
DSLBD Office Fit Out - Broughton Construction Company
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
4. Elastomeric Sealants:<br />
a. Dow Corning Corporation.<br />
b. GE Silicones.<br />
c. Pecora Corporation.<br />
d. Tremco, Inc.<br />
5. Grout Sealer:<br />
a. Bonsal, W. R., <strong>Company</strong><br />
b. Bostik.<br />
c. C-Cure.<br />
d. Custom Building Products.<br />
e. Jamo Inc.<br />
f. MAPEI Corporation.<br />
g. Southern Grouts & Mortars, Inc.<br />
h. Summitville Tiles, Inc.<br />
i. TEC Specialty Products Inc<br />
2.3 PRODUCTS, GENERAL<br />
A. ANSI Ceramic Tile Standard: Provide tile that complies with ANSI A137.1, "Specifications for Ceramic Tile," for<br />
types, compositions, and other characteristics indicated.<br />
1. Provide tile complying with Standard grade requirements, unless otherwise indicated.<br />
B. ANSI Standards for Tile Installation Materials: Provide materials complying with ANSI standards referenced in<br />
"Setting and Grouting Materials" Article.<br />
C. Colors, Textures, and Patterns: Where manufacturer's standard products are indicated for tile, grout, and other<br />
products requiring selection of colors, surface textures, patterns, and other appearance characteristics, provide<br />
specific products or materials complying with the requirements of Appendix A – Schedule of Materials.<br />
D. Factory Blending: For tile exhibiting color variations within ranges selected during Sample submittals, blend tile in<br />
factory and package so tile units taken from one package show same range in colors as those taken from other<br />
packages and match approved Samples.<br />
E. Mounting: For factory-mounted tile, provide back- or edge-mounted tile assemblies as standard with manufacturer,<br />
unless otherwise indicated.<br />
1. Retain subparagraph below if tile is used in swimming pools, on exteriors, or in wet areas. According to<br />
ANSI A137.1, manufacturers must specify whether back- or edge-mounted tile assemblies are suitable for<br />
these installations.<br />
2. Where tile is indicated for installation in wet areas, do not use back- or edge-mounted tile assemblies unless<br />
tile manufacturer specifies in writing that this type of mounting is suitable for installation indicated and has a<br />
record of successful in-service performance.<br />
2.4 TILE PRODUCTS<br />
A. Trim Units: Match characteristics of adjoining flat tile and coordinated with sizes and coursing of adjoining flat tile<br />
where applicable<br />
TILE 09 30 00 - 4