AMBA Design Kit Technical Reference Manual - ARM Information ...

Behavioral ModelsSwitch Options Default DescriptionTable 5-12 Preprocessor command-line options (continued)-outfile = - filestim.m2d Output file name. This name must match the definitionspecified in the file reader bus master HDL.-buswidth = 32 or 64 64 Specifies the data bus width of the target FRM.-arch = ahb2 or V6 ahb2 Specifies the ARM processor architecture version of thetarget FRM.NoteV6 is not supported by this version of the FRM.-StimArraySize = 5000 The size of the file reader bus master file array. This sizemust match the value set in the FRM HDL.Error reporting during file preprocessingThe script performs additional checks to ensure correct FRM operation. Table 5-13 liststhe error checks. File conversion is aborted if an error with the command-line optionsis found. File conversion continues if any other error is found, so that you can generatenon-AMBA compliant stimulus for test purposes, if required.Table 5-13 fm2conv.pl error messagesErrornumberDescription17 Input file is unreadable, does not exist or has incorrect permissions.20 Input file has same name as output file.21 Cannot create output file.32 Unrecognized commands within the file.36 Required fields are missing or in the wrong format.37 Loop command has Number field missing.38 Comment command requires a string within double quotes.40 Size value exceeds the data bus width. Maximum value is dword | size64 for the ADK2 64-bit version FRM,and word | size32 for the ADK2 32-bit version FRM.43 Loop Number field out of range.ARM DDI 0243C Copyright © 2003, 2007 ARM Limited. All rights reserved. 5-27