1 Surgery CAMLOG Compendium
1 Surgery CAMLOG Compendium
1 Surgery CAMLOG Compendium
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Pre-Drilling<br />
Internally irrigated pre-drills, five bladed<br />
cutter, are available for the SCREW-<br />
CYLINDER-LINE Implants; the available<br />
diameters are 2.8 mm / 3.3 mm /<br />
3.6 mm. The recommended drilling speed<br />
is 600 rpm.<br />
The depth marks on the drill match the<br />
implant lengths. For safety reasons, a<br />
depth stop matching the proposed<br />
implant length should be used.<br />
Pre-Drill, five bladed Cutter<br />
Sequence for SCREW-CYLINDER-LINE Implants<br />
Pre-drill<br />
Ø 2.8 mm<br />
For implant<br />
Ø 3.8 mm<br />
Pre-drill<br />
Ø 3.3 mm<br />
Form drill<br />
Ø 3.8 mm<br />
Ø 2.8 mm Ø 3.3 mm Ø 3.6 mm<br />
For implant<br />
Ø 4.3 mm<br />
Pre-drill<br />
Ø 3.6 mm<br />
Form drill<br />
Ø 4.3 mm<br />
Caution!<br />
The Ø 3.6 mm pre-drill must not be used for implant diameter 3.8 mm.<br />
Pre-drill, five bladed cutter, max 600 rpm<br />
The implant bed preparation is performed<br />
with pre-drills, five bladed cutter,<br />
in increasing size with reference to<br />
the selected implant diameter and<br />
insertion depth. Then, the implant bed<br />
is finished to the final size with a form<br />
drill of appropriate length.<br />
Ø 2.8 mm pre-drilling<br />
<strong>Surgery</strong> Manual<br />
SCREW-CYLINDER-LINE Insertion<br />
For implant<br />
Ø 5.0 mm<br />
Form drill<br />
Ø 5.0 mm<br />
Paralleling pin, long,<br />
with depth mark<br />
Ø 2.8 / 3.6 mm<br />
Drilling depth check after<br />
pre-drilling Ø 2.8 mm<br />
For implant<br />
Ø 6.0 mm<br />
Form drill<br />
Ø 6.0 mm<br />
Paralleling pin, short<br />
Ø 2.8 / 3.6 mm<br />
Parallelism/axis<br />
check after pre-drilling<br />
Ø 2.8 mm<br />
99
Change language