1 Surgery CAMLOG Compendium

More documents

Recommendations

Info

<strong>Surgery</strong> Manual SCREW-LINE Insertion Submerged Healing Once the silicone plug has been removed from the handle, the cover screw is lifted with the screwdriver and screwed into the implant manually (Caution! Danger of aspiration). The cover screw must be tightened by hand only, using the screwdriver. Inserting the cover screw Inserting the healing cap 60 Implant with cover screw Wound closure Open/Transgingival Healing In this example, a cylindrical healing cap is picked up with the screwdriver and screwed into the implant manually (Caution! Danger of aspiration). The healing cap should be tightened by hand only, using the screwdriver. Implant with healing cap Wound closure
Accessories Adapter for Screw Implants, long, for narrow Gaps A special reduced-diameter adapter for screw implants, long, is available for implant diameters 3.3 and 3.8 mm to assist manual insertion into small gaps. The setup must be performed under sterile conditions. After removal from the primary package (blister) the color-coded holding sleeve with correct diameter is inserted over the endosseous part of the implant to guide the adapter for screw implants, long, into the screw implant. The holding sleeve is squeezed together like a collet at the level of the implant shoulder and the handle is removed. Next, the insertion post is unscrewed with the screwdriver and removed. Adapter for screw implants, long, Ø 3.3 / 3.8 mm Setting up the holding sleeve Withdrawing the handle Unscrewing the retention screw <strong>Surgery</strong> Manual SCREW-LINE Insertion Holding sleeve for implants to guide the adapter for screw implants, long, into the screw implant, Ø 3.3 mm and Ø 3.8 mm Removing the insertion post 61
Page 1:
CAMLOG Compendium 1 Surgery
Page 4 and 5:
CAMLOG Compendium | 1 Surgery Bibli
Page 6 and 7:
CAMLOG Compendium | 1 Surgery 4. Pr
Page 9 and 10:
I. General System Information 1. In
Page 11 and 12:
3. Implant Configuration Macroscopi
Page 13 and 14:
Bioseal Bevel/Implant Shoulder Foll
Page 15 and 16:
Tube-in-Tube Connection The long-te
Page 17 and 18: 4. Mechanics and Biomechanics Mecha
Page 19 and 20: II. CAMLOG Concept 1. Team Concept
Page 21 and 22: 2. Treatment Concept Introduction I
Page 23 and 24: Fixed Restorations Single Crowns Si
Page 25 and 26: Implant-Supported Bridges Implant-s
Page 27 and 28: Bar supported Dentures Bars are sui
Page 29 and 30: 2. Anamnesis Introduction The medic
Page 31 and 32: Articulator Set-Up The diagnostic c
Page 33 and 34: Planning Template A planning templa
Page 35 and 36: 5. Implant Position Verification Go
Page 37 and 38: Final Prosthesis Design The surgica
Page 39: SCREW-CYLINDER-LINE Implant The SCR
Page 42 and 43: Surgery Manual CAMLOG ® Surgery Sy
Page 44 and 45: Surgery Manual CAMLOG ® Surgery Sy
Page 46 and 47: Surgery Manual Implant Healing 4. H
Page 48 and 49: Surgery Manual SCREW-LINE Insertion
Page 73 and 74: 6. ROOT-LINE Implant Introduction T
Page 75 and 76: Incision Line The sample indication
Page 77 and 78: 13 mm 11 mm 9 mm 13 mm 11 mm 9 mm 1
Page 79 and 80: Paralleling Pin with Depth Marks On
Page 81 and 82: Pre-Drilling An internally irrigate
Page 83 and 84: Depth Stop During form drilling the
Page 85 and 86: Form Drilling Once pre-drilling is
Page 87 and 88: Manual thread tapping is performed
Page 89 and 90: Implant Positioning The protocol-co
Page 91 and 92: Placing the PickUp on the insertion
Page 93 and 94: Next, extract the retention screw o
Page 95 and 96: Accessories Adapter for Screw Impla
Page 97: Accessories Once the retention scre
Page 100 and 101: Surgery Manual SCREW-CYLINDER-LINE
Page 118 and 119:
Surgery Manual SCREW-CYLINDER-LINE
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
116
Page 126 and 127:
Surgery Manual CYLINDER-LINE Insert
Page 128 and 129:
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Page 136 and 137:
Page 138 and 139:
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
136
Page 146 and 147:
Surgery Manual Healing Cap Healing
Page 148 and 149:
Transfer System Introduction 10. Tr
Page 150 and 151:
Transfer System Closed Impression M
Page 152 and 153:
Transfer System Open Impression Met
Page 154 and 155:
Transfer System Open Impression Met
Page 156 and 157:
Provisional Solution Introduction 1
Page 158 and 159:
Provisional Solution Preparing the
Page 160 and 161:
General Information Torque Wrench S
Page 162 and 163:
General Information Torque Wrench C
Page 164 and 165:
156
Page 166 and 167:
Informations Materials Titanium Gra
Page 168 and 169:
160
Page 170 and 171:
162
Page 172:
➤ ➤ ISBN 978-3-13-134351-2 CAML
show all

1 Surgery CAMLOG Compendium

Create successful ePaper yourself

Delete template?

Save as template?