1 Surgery CAMLOG Compendium
1 Surgery CAMLOG Compendium
1 Surgery CAMLOG Compendium
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Surgery</strong> Manual<br />
ROOT-LINE Insertion<br />
Implant Bed Preparation<br />
Overview of the implant bed preparation.<br />
• Punch mark the desired implant position<br />
with the internally irrigated<br />
Ø 3.5 mm round bur.<br />
• Deep drill along the implant axial line<br />
with the internally irrigated Ø 2.0 mm<br />
pilot drill.<br />
• Check with the Ø 2.0 / 3.3 mm paralleling<br />
pin with depth marks.<br />
• Pre-drill with the internally irrigated<br />
Ø 2.8 mm pre-drill.<br />
• Check with Ø 2.8 / 3.6 mm paralleling<br />
pin with depth marks.<br />
• Shape with internally irrigated form<br />
drill.<br />
• Probe the implant bed hole for its<br />
bony end.<br />
• Use ROOT-LINE/SCREW-CYLINDER-<br />
LINE tap (for bone qualities D1 and<br />
D2).<br />
68<br />
Drilling Sequence<br />
Ø 3.8 mm<br />
Ø 4.3 mm<br />
Ø 5.0 mm<br />
Ø 6.0 mm<br />
Round bur Ø 3.5 mm<br />
16 mm<br />
13 mm<br />
11 mm<br />
9 mm<br />
Depth stop<br />
Paralleling pin<br />
Ø 2.0/3.3 mm<br />
rpm 800 800 600<br />
Round bur Ø 3.5 mm Round bur Ø 3.5 mm<br />
Round bur Ø 3.5 mm<br />
16 mm<br />
13 mm<br />
11 mm<br />
9 mm<br />
Depth stop<br />
rpm 800 800 600<br />
16 mm<br />
13 mm<br />
11 mm<br />
9 mm<br />
Depth stop<br />
rpm 800 800 600<br />
16 mm<br />
13 mm<br />
11 mm<br />
9 mm<br />
Pilot drill Ø 2.0 mm<br />
Pilot drill Ø 2.0 mm<br />
Pilot drill Ø 2.0 mm<br />
Pilot drill Ø 2.0 mm<br />
Depth stop<br />
Paralleling pin<br />
Ø 2.0/3.3 mm<br />
Paralleling pin<br />
Ø 2.0/3.3 mm<br />
Paralleling pin<br />
Ø 2.0/3.3 mm<br />
rpm 800 800 600<br />
The height of the depth stop for the form drill is 2 mm.<br />
* If the bone quality is D1 or D2, use of the tap (thread cutter) is recommended<br />
for ROOT-LINE Implants.<br />
Pre-drill Ø 2.8 mm<br />
Pre-drill Ø 2.8 mm<br />
Pre-drill Ø 2.8 mm<br />
Pre-drill Ø 2.8 mm