power distribution - Siemens

"X1X1X1X1"Heavy Duty Motor StartersClass 143-Phase and Single Phase Magnetic StartersAmbient CompensatedSingle Phase Sizes 00-2 1/2Ambient Compensated3-Phase Sizes 00-2 1/2Wiring DiagramsAmbient Compensated3-Phase Sizes 3-4Solid State OverloadSingle Phase Sizes 0-1Solid State Overload3-Phase Sizes 00-4Solid State Overload3-Phase Sizes 5-8POWER WIRING:USE 75°C COPPER WIRE ONLY.INCOMING LINEA B CSIZECT RATIOCIRCUITPROTECTIVEDEVICE(IF USED)5300:52CTNOTE A6600:5A "16CONTROLPRODUCTS78750:51200:5CONTACTORCURRENTTRANSFORMERL1/1 L2 L33 A1 A2M2B "C"""REMOVE WIRE C " IF THE CONTACTORCOIL IS TO OPERATE ON A VOLTAGEOTHER THAN LINE VOLTAGE OR ON ASEPARATE CONTROL SOURCE.(WHEN USED, SEE TABLE)1CT 2CT 3CT95RELAY(IF USED)O.L.96T1T2T3NOTES:NEMA & GeneralPurpose ControlSolid State Overload 3-PhaseWired as 1-Phase A: 2CT IS LOCATED ON THE LINE SIDEOF CONTACTOR ON SIZE 7 STARTERS ONLY.LOAD Warning: The ESP100 Starter and Single Phase Motormust be wired with polarity as shown. Neutral and L1wires must be wired as indicated on the drawing.Polarity is indicated by the arrows.16-130 Full Load Amps (FLA): Adjustment of the ESP100 solidstate overload relay (OL) must be made as follows toaccommodate the single phase motor: For an approximatesetting of a single phase motor application,multiply the motor nameplate FLA by .75 and set theSiemens Power Distribution & Control, SPEEDFAX 2007-2008 Product Catalogdial on the overload relay (OL) to resulting value. The 3-phase for frame size A (without windows) can notbe wired for single phase. Use the proper version forsingle phase.