2018-2019 Horticultural Catalog

Atomizing Humidifier
Model 707-U
• Humidifies 3000 cubic feet to exact degree of humidity. There is a float in
the plastic base pan to control the water level
• Output is approximately 6 gallons/day at 120°F
• Rust and corrosion resistant
• Included wire-in humidistat is easily adjustable from 20% to 80%
relative humidity
• Includes self tape saddle and wall bracket
Size: 10.5” Diameter x 12”High Weight: 13 lbs
Humidifiers & Humidistats
humidifiers • humidistats
Universal Humidistat
Model 82-1A
Easy installation – no wiring. Plug any humidifier into the
back of the humidistat plug for automatic humidity control.
Ideally suited for use with portable humidifiers. When
the humidity in the installation location drops from the
selected setting, the 82-1A activates the humidifier and
allows it to operate until the humidity again reaches the desired level.
The 82-1A will control humidifiers with up to 1⁄4 hp motors. A 6 ft, threeconductor,
grounded cord with a three-prong plug is included with each
unit. “On” and “Off” setting positions are provided for manual operation
of the humidifier.
Direct Feed Humidifier
Model Hydro SS-700-DF
*Cord and plug are
not included; must
be hard wired
Description Catalog # Each
Humidifier* 120V 33-25000 $ 350.00
Humidistat 33-25100 145.00
Replacement Motor w/cover 33-25010 175.00
Wall Bracket (hardware not incl.) 33-25020 32.00
10’ Tubing 33-25030 23.35
Self Tapping Saddle Valve 33-25040 6.79
Aquafog Hydro atomizing fans are quiet, dependable and perfectly suited for
the smaller job. The Direct Feed hanging units receive liquid directly through
a visual flowmeter control panel. This provides for fine “repeatable” control
of the fogging output as well as enhancing dependability by eliminating
sump components. Direct Feed units are well suited for the harsher environment
or applications where standing water in a sump could become an
issue. Each unit is equipped with a 5 gph (20-300cc/min) flow meter panel
and 12’ condensation drainage line.
• 3 gph fogging capability
• Consumes extremely low amounts of energy
• Adjustable angle fogging head
• No-clog, nozzle-free atomization
Flowmeter
• Adjustable flow output with fog particles averaging 40 microns in size
with strainer
• 14’ power cord with grounded three prong plug
• 15’ of 1/4” water line tubing with water house connector
• Can accept water supply from any source, even ponds without the risk of clogging
• Does not require high pressure lines like other foggers
Specifications:
Fogging Capacity 0-3 gallons/hour
CFM Rating 1,125
Energy Consumption 1.5 Amps @ 115V
Noise @ 10’
62 db(A)
Weight
10.5 lbs
Dimensions
16” diameter x 20.5” length
Voltage
110-128 Volts, 60Hz, 1ph
Coverage
Humidification: about 500 sq ft
Evaporative cooling: about 300 sq ft
Model Description Catalog # Each
SS-700-DF Direct Feed Humidifier 33-38840 $ 550.00
Humidistat/Solenoid Control
Model XE-36-DF
This pre-wired humidistat combination water
solenoid, is an ideal means of control for the
Hydro 700 Direct Feed unit in all applications
requiring 85% or less relative humidity.
Automatically controls both the electrical and water supply for the Direct Feed units. Ideal for
most humidification and indoor cooling applications, it incorporates a fast-acting man-made
sensing element with large easy access control dial. Designed to endure high humidity levels,
this control unit requires no wiring and comes supplied with a convenient 8’ pre-wired piggyback
electrical plug.
Model Description Catalog # Each
SHIPPED FOB: Pennsylvania
XE-36-DF Humidistat - 110-250V 33-38610 $ 150.00
550 800-325-3055
www.hummert.com