VF-FS1 Industrial Inverter - Toshiba

6
Setting of switching terminals
F-16
E6581381
The terminal for switching to motor 2 needs to be set, since this function is not assigned under the default
setting. Assign this function to an idle terminal.
The parameters to be switched depend on the particular identification number of the input terminal selection
function.
5
AD2
Input terminal function number
39
VF2
40
MOT2
61
OCS2
OFF OFF OFF OFF
ON OFF OFF OFF
Parameters used and applicable parameters
Default setting: , , , , , ,
, ,
→ , → ,
→
OFF OFF OFF ON →
OFF ON OFF OFF
- - ON -
= , → , → ,
→ , →
= , → , → ,
→ , → ,
→ , → ,
→ , →
Note: The parameters , , , and cannot be switched during operation. You need
to stop operation when switching them.
6.5 Frequency priority selection
6.5.1 Using a frequency command according to the particular
situation
: Frequency setting mode selection 1
: Frequency priority selection
: Speed setting mode selection 2
• Function
These parameters are used to switch between two types of frequency command signals.
• Setting by parameters
• Switching by frequency
• Switching via terminal board input