VF-FS1 Industrial Inverter - Toshiba

8. Monitoring the operation status
Refer to section 4.1 about flow of monitor.
8.1 Status monitor mode
8.1.1 Status monitor under normal conditions
Note 1
Note 2
Note 3
Parameter setting
mode
Direction of
rotation
H-1
E6581381
In this mode, you can monitor the operation status of the inverter.
To display the operation status during normal operation:
Press the MODE key twice.
Setting procedure (eg. operation at 60Hz)
Item displayed
Key
operated
LED
display
Communic
ation No.
Description
The operation frequency is displayed (Operation at
60Hz). (When standard monitor display selection
is set at 0 [operation frequency])
The first basic parameter “” (Wizard function)
MODE
is displayed.
Operation
frequency
command
FE01
FE02
Load current FE03
Input voltage FE04
The direction of rotation is displayed.
(: forward run, : reverse run)
The operation frequency command value (Hz/free
unit) is displayed.
The inverter output current (load current) (%/A) is
displayed.
The inverter input voltage (DC detection) (%/V) is
displayed.
Output voltage FE05 The inverter output voltage (%/V) is displayed.
Torque FE18 The torque (%) is displayed.
Torque current FE20 The torque current (%/A) is displayed.
Inverter load factor FE27 The inverter load factor (%) is displayed.
Input power k FE29 The inverter input power (kW) is displayed.
Output power FE30 The inverter output power (kW) is displayed.
Operation
frequency
(Continued overleaf)
MODE
FD00
The operation frequency (Hz/free unit) is
displayed.
8