VF-FS1 Industrial Inverter - Toshiba

E-9
E6581381
Title Function Adjustment range Default setting
Frequency setting mode selection 1
[Programmed value]
: VIA input
: VIB input
: Operation panel
1: VIA
2: VIB
3: Operation panel
4: RS485 communication
5: UP/DOWN from external contact
A frequency command is set by means of a signal from an external input device
(VIA terminal: 0-10Vdc or 4-20mAdc).
An external signal (VIB terminal: 0-10Vdc) is used to specify a frequency
command.
Press the key or the key on either the operation panel or the
expansion panel (optional) to set frequency.
: Communication Frequencies are set by commands from an external control unit.
: UP/DOWN frequency Terminals are used to specify an up/down frequency command.
No matter what value the command mode selection and the frequency setting mode selection
are set to the control input terminal functions described below are always in operative state.
• Reset terminal (default setting: RES, valid only for tripping)
• Standby terminal (when programmed by programmable input terminal functions).
• External input tripping stop terminal command (when so set using the programmable input terminal
function)
To make changes in the command mode selection and the frequency setting mode selection 1
, first stop the inverter temporarily.
Preset-speed operation
: Set to (Terminal board).
: Valid in all setting values.
1
5