VF-FS1 Industrial Inverter - Toshiba

3.1.1 How to start and stop
Example of a setting procedure
Key operated LED display Operation
MODE
ENT
ENT
Displays the operation frequency (operation stopped).
(When standard monitor display selection = [Operation
frequency])
Displays the first basic parameter [Wizard function ()].
Press either the or key to select “”.
Press ENT key to display the parameter setting. (Default setting:).
Change the parameter to (panel) by pressing the key.
⇔
Press the ENT key to save the changed parameter. and the
parameter set value are displayed alternately.
(1) Start and stop using the operation panel keys (=)
Use the RUN and STOP keys on the operation panel to start and stop the motor.
RUN : Motor starts. STOP
: Motor stops.
To switch between forward run and reverse run from the control panel, the parameter
(forward/reverse run selection) needs to be set to or .
C-3
E6581381
(2) RUN/STOP by means of an external signal to the terminal board (=):
Sink (Negative) logic
Use external signals to the inverter terminal board to start and stop the motor.
Short F and CC terminals: run forward
Open F and CC terminals: slow down and stop
(3) Coast stop
The standard default setting is for slowdown stop. To
make a coast stop, assign a "1(ST)" terminal function
to an idle terminal using the programmable terminal
function.
Change to =.
For coast stop, open the ST-CC when stopping the
motor in the state described at left.The monitor on the
inverter at this time will display .
Frequency
Motor
speed
F-CC
ST-CC
F-CC
Coast stop
Slow down
and stop
ON
OFF
ON
OFF
ON
OFF
3