Download as PDF - Touratech Nordic

BMW F800GS
Hard Part Radiator, BMW F800GS
The radiator of the F800GS is only screwed to the frame at one point; all other attachments consist of slot-in
rubber bearings. A fall or extreme loads when riding off-road can cause the plastic loop to tear off - which
usually spells the end of the ride! This strong Hard Part, made of 3 mm stainless steel, is a replacement for
this angle bracket, and provides additional support for the radiator on the filler neck. This means the radiator
is securely attached, and is effectively protected against sliding out of the rubber bearings. The original
screws can be reused.
048-0465
Hard Part for BMW Engine Guard, F800GS
The Hard Part for the original BMW engine guard consists of hard wearing rubber mats and an air
permeable, heat resistant fleece. The fleece has already proved extremely successful with the Touratech
Racing Team. It effectively prevents the spaces between the
engine guard and the engine from blocking and stones
from collecting and settling there. The fleece can be cut
or trimmed as required, and is secured neatly and
unobtrusively with cable ties. The rubber mats are glued
directly to the guard, thereby preventing stones from
settling between the oil reservoir and engine guard. The
BMW engine guard Hard Part prevents stuck stones from
penetrating the oil reservoir and tearing off the rubber
bearings on the engine guard in the event of bottoming
out and impacts.
048-0460
made for adventure
485