VMX12 Service Manual - V-Max Outlaw

2-31
WHEEL BEARINGS CHECK/TIRES CHECK
the lock washer .
NOTE:
Make sure the lock washer tab is placed in
the slots.
the steering crown and tighten
the steering stem nut to specification.
11. Install:
Nut (Steering Stem) :
110 Nm (11.0 m-kg, 80 ft-lb)
in above list (steps"6 2")
Handlebar Lower Holder:
40 Nm (4.0 m-kg,29 ft-lb)
WHEEL BEARINGS CHECK
Front Wheel
1. Check:
Front wheel bearings
Raise the front end of the motorcycle, and
spin the wheel by hand. Touch the axle or
front fender while spinning the wheel.
Excessivevibration Replace bearings.
Rear Wheel
1. Remove:
Rear wheel
2. Check:
movement
With the fingers.
Roughness/Wear Replace.
TIRES CHECK
Do not attempt to use tubeless tires on a wheel
designed for tube type tires only. Tire failure
and personal injury may result from sudden
deflation.
I