VMX12 Service Manual - V-Max Outlaw

6-33
FRONT FORK
8. Install:
Fork spring
With smaller pitch side up.
*Spring seat
bolt
Temporarily tighten the cap bolt.
INSTALLATION
1. Install:
Front
underbracket.
Circlip
Onto inner tube.
Apply a light coat of lithium base grease
to the O-rings in the air joint bracket.
joint bracket
Rubber damper
Over inner fork tube.
2. Tighten:
Pinch bolts (under bracket)
Temporarily tighten the pinch bolts.
NOTE:
Position the inner tube end so that it is flush
with the top of the steering crown.
3. Tighten:
Pinch bolts (under bracket)
Pinch Bolts (Under Bracket):
23 Nm (2.3 17
NOTE:
Do not tighten the pinch bolt (steering crown)
in this stage.
I
4. Tighten:
bolt
Use the Front Fork Cap Socket
01104).
*Pinch bolt (steeringcrown)
23 Nm (2.3 17
Pinch Bolts (SteeringCrown): 20 Nm (2.0 14
I