VMX12 Service Manual - V-Max Outlaw

--
2. Measure:
V-BOOST
Betweenthe pulley and the adjuster .
Out of specification Adjust.
Lockunt
3. Adjust:
m (0.012 0.004 in)
By the following adjustment steps.
Clearance adjustment steps:
First step:
NOTE:
Do not loosen the locknut in this stage.
the lock bolt .
on the main switch for the servo motor
initial operation (valve closed position).
NOTE:
By performing these steps, and appropriate
tension for the control cable 1 can be
obtain with the spring in the joint .
the lock bolt to specification.
Lock Bolt:
3.5 Nm (0.35 2.5
the clearance . If not, perform
the next step.
Second step:
Loosen the locknut
the adjuster clockwise or counterclockwise
until proper clearance is attained.
the locknut. Apply to
the locknut.
5-14