VMX12 Service Manual - V-Max Outlaw

SHAFT DRIVE
Hundredths Round
I I 0 I
In the example above, the calculated shim
thickness is 0.46 mm. The chart instructs
however, to round off the 6 to 5.
Thus you should use a shims.
2. Install:
*Shims (proper size as calculated)
Final drive shaft assembly
Bearing retainer (final drive shaft)
Use a Final Drive Shaft Bearing Retainer
Wrench
NOTE:
The bearing retainer has left-hand threads; turn
retainer counterclockwise to tighten it.
Bearing Retainer:
110 Nm (11.0
Install:
Coupling gear
nut (coupling gear)
Use a Final Drive Shaft Holder
01
locking Nut ing Gear)
110 Nm (11.0 80
LOCTI
4. Install:
Ring gear assembly (without thrust washer)
5. Adjust:
lash
Refer to "Gear Lash Measurement and
Adjustment" section.
6.
Ring gear thrust clearance
By the following measurement and selection
steps.
i
6-60