VMX12 Service Manual - V-Max Outlaw

ENGINE ASSEMBLY AND ADJUSTMENT
4. Install:
Camshafts
By the following installation steps.
t installation steps:
the mark on the flywheel
with the stationary pointer on the crankcase
cover use 32 mm wrench.
Never turn the flywheel installing bolt.
Rotating the bolt may loosen it, causing
the rotor to fall out.
not turn the crankshaft during the camshafts
installation.
the cam chain sprockets onto the
camshafts.
VOTE:
sure the "REAR" mark on the cam
sprockets face away from the "IN"
nark and "EX" mark on the camshafts.
engine oil to the camshaft bearing
surfaces.
Install the "IN" marked camshaft onto the
intake side and "EX" marked camshaft onto
the exhaust side.
the camshafts by hand so that the
timing markes small hole) on the
camshaft face upward.
Install the dowel pins into the cam caps.
the cam caps (Nos. and 4) onto
the camshaft.
NOTE:
not install No. 2 intake and No. 2 ex.
haust cam caps atthis stage.
numbers are punched on the camshaft
caps in increments from right to
left.