VMX12 Service Manual - V-Max Outlaw

THROTTLE CABLE CYLINDER
Second step:
a. Loosen the locknut (carburetor side).
b. Turn the adjuster (carburetor side) counterclockwise
a little.
c. Turn adjuster (throttle grip side) clockwise
so that the free play (throttle grip) is
within 4 - 7 mm (0.16- 0.28 in).
d. Check to see if throttle valve operates at
full open.
If not, repeat steps a-d.
e. Tighten locknut (carburetor side).
f. Check to see if throttle valve operates at
full open or full closed.
Throttle valve fails to operate at full open
or full closed Perform the next step.
Third step:
to see if throttle cable installation
iscorrect.
NOTE:
Be sure that the silver throttle cable is positioned
opposite the adjusters.
Check the position of the control cable
sliders in the throttle cable cylinder.
NOTE:
sure the open side slider (silver cable side)
falls between the three adjustment marks on
the carburetor side.
sure the closed side slider falls between
the two adjustment marks on the throttle
grip side.
the fall outside the adjustment
marks then the throttle must be
replaced.
Cable adjustment mark (Open side)
Cable adjustment mark (Closed side)
5-12