VMX12 Service Manual - V-Max Outlaw

3-41
INSPECTION AND REPAIR
3. Install:
Bearings
Into the upper crankcase.
4. Install:
Balancer shaft
Into the upper crankcase.
5. Attach:
Onto the balancer shaft journal surface.
NOTE:
Do not move balancer shaft until clearance
measurement has been completed.
6. Install:
Bearings
Into lower crankcase.
7. Tighten:
Bolts (crankcase)
Tighten to full torque in torque sequence cast
on the crankcase.
8 mm Bolt (Crankcase):
24 Nm (2.4 kg, 9.6
8. Remove:
Bolts
Reverseassembly order.
(lower)
Use care in removing.
9. Measure:
width
Out of specification Replace bearings;
replace balancer shaft in necessary.
Balancer Shaft Bearing Oil Clearance:
0.020- 0.048 mm
(0.0008 0.002 in)
I
I