VMX12 Service Manual - V-Max Outlaw

6-25
HYDRAULICCLUTCH
2. Install:
rod
0 Lever
9 Nm (0.9 6.5
Clutch Hose:
NOTE:
Grease the pivot point
3. Fill:
0 Master cylinder
4. Bleed the air completely from the clutch
system.
AIR BLEEDING
Bleed the clutch system it:
0 The system has been disassembled.
A clutch hose has been loosened or removed.
The clutch fluid is very low.
clutch operation isfaulty.
1. Bleed:
fluid (brakefluid)
By the following steps.
Air bleeding steps:
a. Add proper brake fluid to the reservoir.
b. Install the diaphragm. Be careful not to
spill any fluid or allow the reservoir to over
flow.
c. Connect the clear plastic hose to the
bleed screw.
d. Place the other end of the tube into a
container.
e. Slowly apply the clutch lever several times.
f. Pull in the lever and hold it in position.
g. Loosen the bleed screw and allow the lever
to travel slowly toward its limit.
h. Tighten the bleed screw when the lever
has reached its limit, then release the lever
6 Nm (0.6 kg, 4.3