VMX12 Service Manual - V-Max Outlaw

MIDDLE GEAR SERVICE
4. Attach:
Damper Spring Plate (YM-33286)
Drive Gear Holder (YM-33222)
5. Position:
Drive axle shaft assembly
Onto a Hydraulic Press.
6. Compress the damper spring on the drive
axle assembly.
7. Install:
Retainers
drive axle shaft groove.
Drive axle shaft assembly
Onto the crankcase.
MIDDLE DRIVEN GEAR BEARINGS
The following procedures should be performed
only if the middle driven gear or middle drive
shaft must be replaced.
Universal Joint Removal
1. Remove:
Universal joint
By the following.
Universal joint removal steps:
Remove the
Place the U-joint in a press.
a suitable diameter pipe beneath the
yoke, press the bearing into the pipe as
shown.
NOTE:,
It may be necessary to lightly tap the yoke
with a punch.
Repeat the steps for the opposite bearing.
Remove the yoke.
NOTE:
It may be necessary to lightly tap the
with a punch.
2. Attach:
Universal Joint Holder (YM-04062)
Onto the universal joint yoke.
3-52