VMX12 Service Manual - V-Max Outlaw

I
57
I
SHAFT DRIVE
5. Install:
Guide collar
(new)
Roller bearing (outer race)
Use a suitable press tool and a press to
install the above components into the
main housing.
Final Gear Positioning
Gear positioning is necessary when any of the
following parts are replaced:
0 Final gear case
0 Ring gear bearing housing
1. Select:
Final drive gear shim
Ring gear shim
By the following selection steps.
Final gear shim selection steps:
final drive shaft gear and ring gear
by using shims and with their respective
thicknesses calculated from information
marked on final gear case and drive
gear end.
thickness "A"
thickness "B"
washer
find shim thickness "A" use following
la:
Final Drive Gear Shim Thickness: