VMX12 Service Manual - V-Max Outlaw

6-39
STEERING HEAD
@Check the steering stem by turning it lock
to lock. If there is any binding, remove the
steering stem assembly and inspect the
steering bearings
Install the washer
Install the ring nut (upper)
NOTE:
The tapered side of ring nut must face downward.
tighten the ring nut then align
the slots of both ring nuts. If not aligned,
hold the lower ring nut and tighten the
other until they are aligned.
Install the lock
NOTE:
Make sure the lock washer tab is placed in the
slots.
the steering crown and tighten
the steering stem nut to specification.
Nut (Steering Stem):
110 Nm (11.0 80
the pinch bolts to specification.
Pinch Bolt (Steering Crown):
20 Nm (2.0 14
5. Install:
Components in aforementioned list (steps
"7
Handlebar Lower Holder:
40 Nm (4.0 29