2 - Fagor Automation

Auxiliary modules
4.
AUXILIARY MODULES
Mains filters
204
DDS
HARDWARE
Ref.1209
190
4.1 Mains filters
i
In order to comply with European Directive 2004/108/EC on Electromagnetic
Compatibility, it is mandatory to insert a mains filter. Particularly, the
standard IEC 61800-3 for category C3 and the standard IEC 61326-3-1
for immunity.
The mains filters of the Fagor catalog are referred to as MAINS FILTER
xA.
They are installed between mains and the DDS servo system (modular or
compact) in order to reduce conducted disturbances caused by the drive
down to the levels indicated by the standard mentioned earlier and, at the
same time, make it immune to transient over-voltage like bursts or voltage
pulses.
MAINS FILTER xA. Technical data
F. H4/1
Mains filters.
T. H4/1 Technical data.
MAINS FILTER 42A 130A 180A
Rated voltage 3 phases: 380 V AC - 480 V AC (50/60 Hz)
Rated current
(rating @ 50°C/122°F)
42 A 130 A 180 A
Approximate mass 2.8 kg / 6.2 lb 7.5 kg / 16.5 lb 11 kg / 24.2 lb
Rated leak current 0.50 mA 0.75 mA 0.75 mA
Max. leak current 27 mA 130 mA 130 mA
Power loss 19 W 40 W 61 W
Sealing IP 20 IP 20 IP 20
T. H4/2 Technical data of the connection terminals.
MAINS FILTER 42A 130A 180A
Max. tightening torque (Nm) 1.8 8 18
Terminals min./max. section (mm²) 1/6 16/50 35/95
INFORMATION. Note that this filter must be mounted near the drive.
Chapter 6. POWER LINE CONNECTION shows the strict rules that
must be followed to properly install the mains filters. Chapter 11. DIMEN-
SIONS of this manual shows the dimensions.