2 - Fagor Automation

1.2 General diagram
See the schematic description of all the elements that make up the DDS servo drive system:
Mains connection.
Three phase 50/60Hz.TN mains
400-10% to 460+10% V AC
Mains filters:
MAINS FILTER A
Capacitor module CM 1.60. It
is connected in parallel to the
power bus (600 V DC).
Synchronous motors
F. H1/2
DDS servo drive system configurations.
Non-Regenerative
Power Supplies
Non-Regenerative Power Supplies
(they integrate the auxiliary power supply
Regenerative Power Supplies
(they integrate the Auxiliary Power Supply):
Regenerative Regulated
Power Supplies
(they integrate the
Auxiliary Power Supply):
PS-25B4
+ modular drives:
for axes: AXD, MMC
for spindle: SPD
Compact Drives
(they integrate the Power Supply)
for axes: ACD, CMC
for spindle: SCD
PS-65A
+ modular drives:
for axes: AXD, MMC
for spindle: SPD
+ auxiliary power supply:
APS-24
XPS-XX
+ Choke XPS-XX
+ Modular Drives:
RPS-XX
for axes: AXD, MMC
+ Choke RPS-XX for spindle: SPD
+ Modular Drives:
for axes: AXD, MMC
for spindle: SPD
Resistor modules ER+TH-x/x or ER+TH-
18/x+FAN. They are connected to the
power supplies or to the compact drives.
Asynchronous motors
FKM FXM FM7/FM9 SPM
(discontinued)
Description
DESCRIPTION
General diagram 1.
DDS
HARDWARE
Ref.1209
27