2 - Fagor Automation

The next table shows the signals and other considerations related to each
pin of connector X2:
T. H2/20 Description of the pins of connector X2.
1 Error RESET
System error RESET input
(24 V DC; 4.5-7 mA).
2 N. C. Not connected
0 volts reference for digital inputs.
3 GND
Error RESET (1) and
System Speed Enable (5).
4 N. C. Not connected
5 System Speed Enable
General system speed enable.
(24 V DC; 4.5-7 mA).
6 System OK Contact indicating module status.
It opens in case of failure.
7 System OK
Limit 1 A at 24 V.
X3, X4, X5 and X6 connectors
These connectors belong to the auxiliary power supply integrated into the
main power supplies XPS-25 and XPS-65.
1
3
Phoenix
7.62 mm
1
3
Phoenix
5.08 mm
XPS-25
XPS-65
1
2
3
X4 X5
1
2
3
F. H2/25
Connectors X3, X4, X5 and X6 that belong to the auxiliary power supply
integrated into regenerative power supplies XPS-25 and XPS-65.
Connector X3 receives power from mains. It admits a voltage between
400 and 460 V AC.
This auxiliary power supply generates 24 V DC and its purpose is to feed
the control circuits of the module itself. Also, it supplies up to 8 A of this
dc voltage through connectors X4, X5 and X6. These three connectors
are identical and offer greater connecting flexibility.
X3
X6
400-460 VAC
+24 VDC
0 VDC
Power supplies
POWER SUPPLIES
Regenerative power supplies 2.
DDS
HARDWARE
Ref.1209
63