2 - Fagor Automation

Once the display shows the desired speed, apply a long push and QP11
will be assigned its associated value that will be saved into the flash
memory of the drive and will reset the drive.
F. H8/37
Diagram of the CAN transmission speed selecting procedure.
Anomalous events during the procedure
Any error that comes up when saving parameters into flash memory, will
be displayed with an error message on the display while the "boot" button
is pressed and then it will return to state 1 (speed selection).
Any attempt to select a value other than those assigned to the possible
transmission speeds will generate an error and it will not be selected.
Any change of the communication speed is maintained after the drive is
turned off if the command to save parameters has been previously executed
successfully.
If, for any reason, the drive is turned off or "reset" in any stage of this procedure,
when started up again, the transmission speed value given by
QP11 will be the last one that was successfully assigned in previous
changes.
The speed change procedure may be ignored (without making any changes)
at any time if the command to save parameters has not been executed.
While in state 1, after 8 seconds without pressing the "boot" button, the
drive switches to 0 state and the display shows the initial information.
Installation
INSTALLATION
Connection of the control and communications signals 8.
DDS
HARDWARE
Ref.1209
305