2 - Fagor Automation

Power supplies
2.
POWER SUPPLIES
94
62
Regenerative power supplies
DDS
HARDWARE
Ref.1209
1x
Other connectors
X1 connector
The communication between all the modules that make up the DDS servo
drive system is established through connector X1.
X1
F. H2/23
Connection of the internal bus between modules through connector X1.
A ribbon cable is provided with each module (power supply or drive) for
this connection.
X2 connector
The power supply module may be controlled through X2.
Phoenix
5.00 5.08 mm
1
7
XPS-25
XPS-65
F. H2/24
Control of the power supply module through connector X2.
The internal circuits are protected with a 1.25 A fuse.
1
2
3
4
5
6
7
Gnd
System
Speed Enable
System ok
The following table shows the values for gap, tightening torque, sections
and other data of the plug-in connector for X2.
X2
Error Reset
MANDATORY. Remember that the internal circuits of PS-65A non-regenerative
power supplies must be powered by an external 24 V DC power
supply, "APS-24"; that's why its control connector has three terminals
more than connector X2 of the XPS.
T. H2/19 Data of the plug-in connector for X2.
Connector data XPS-25 XPS-65
Nr of poles 7 7
Gap (mm) 5.00 5.00
Min/max tightening torque (N·m) 0.5/0.6 0.5/0.6
Screw thread M3 M3
Min./max. section (mm²) 0.2/2.5 0.2/2.5
Rated current In (A)
Wire data
12 12
Length to strip (mm) 7 7