2 - Fagor Automation

OPERATION DIAGRAM
Note 1. - KA3 is a relay for a
delayed deactivation of contactor
- KM1 (t seconds) in order to be
able to keep it closed long enough
to return to mains (with XPS
power supply) the excess energy
generated while braking the
motor.
Make sure that the delay "t" programmed
at relay - KA3 is slightly
longer than the braking time of
the application.
The delay disconnection time "t" to
be programmed at relay - KA3
must be greater than the total
amount of time required to brake
the motor to a full stop. See
parameter GP9 in the "dds-software"
manual.
Note 2. CNC EMERG. will always
be assigned to I1/O1 of the PLC
with an 8055/55i CNC. With an
8070 CNC, it may be assigned to
any I/O of the PLC.
The contacts associated with
relays - KA2 and - KA3 are shown
inside a circle in figure F. H10/25.
EMERG.
STOP
XPS
SYSTEM OK
S_SCD
DR.S OK
I1 PLC
CNC EMERG.
O1 PLC
-KA1
+24VDC
X+
X-
Z+
Z-
KA1 KA3
ON KM1 KA2
F. H10/27
Mixed system with SERCOS or CAN connection. Diagram of the maneuver.
OFF
EMERGENCY LINE
-KA2 -KM1
SYSTEM
SPEED
ENABLE
GND
ON
Green
OFF
Red
SPEED
ENABLES
DELAY
-KA3 OFF
DRIVE t seconds
ENABLES
(See GP9)
ON OFF
Connection diagrams
(See GP9)
BRK
KA1
KA2 KA2
BRAKE LINE
CONNECTION DIAGRAMS
Diagrams of a mixed (combined) system with CAN connection 10.
DDS
HARDWARE
Ref.1209
351