2 - Fagor Automation

Connection to the external Ballast resistor
The external resistor modules are designed to be installed in the corresponding
terminals of the power supplies or compact drive modules (with
an integrated power supply) in order to dissipate the excess energy generated
when braking the servomotors.
See chapter 5, the section regarding the "external Ballast resistor selection
guide" to know whether it is necessary or not to install an external
Ballast resistor or the internal one is enough.
See chapter 4, section "Resistor modules", for further detail on the external
Ballast resistors associated with the power supplies and with the compact
drives when required to install one.
Resistor configurations with power supply
Configuration
for connecting the
internal
Ballast resistor
PS-25B4
XPS-25
R. int
L-
PS-65A
XPS-65
R. int
L-
CONTROL
CONTROL
Ri Re L+
Configuration
for connecting the
internal
Ballast resistor
L+
Ri Re L+
L+
Configuration
for connecting the
external
Ballast resistor
Configuration
for connecting the
external
Ballast resistor
R. ext
2x ER+TH-18/X
2x ER+TH-18/X+FAN
PS-65A
XPS-65
R. int
CONTROL
Ri Re L+
F. H8/12
Electrical configurations of the ballast resistor for power supplies.
L-
R. ext
ER+TH-18/X
ER+TH-18/X+FAN
PS-25B4
XPS-25
R. int
CONTROL
Ri Re L+
WARNING. Never connect an external resistor in parallel with the internal
Ballast resistor. It may cause severe damage to the system.
L-
L+
L+
Installation
INSTALLATION
Connection between modules 8.
DDS
HARDWARE
Ref.1209
283