Jaguar XJ 1998 - JagRepair.com

CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR
MODULE
0 Pin Description
DRIVER DOOR CONTROL
v Pin Description
lGNlT,ON SwlTCHED GROUND
SEAT HEATER STATUS iLHD = PASSENGER, RHD = DRIVER)
IGNITION SWITCHED GROUND
SEAT HEATER REOUEST (LHD = PASSENGER. RHD = DRiVERi
STARTER ENGAGE REOUEST
SEAT HEATER STATUS iLHD = DRIVER. RHD = PASSENGER,
BATTERY SUPPLY VOLTAGE
SCP NETWORK
SCP NETWORK
SEAT HEATER REOUEST iLHD = DRIVER, RHO = PASSENGER,
MODULE
I DD10-1 BA”ERY POWER SUPPLY
I DD10-8 LOGIC GROUND
S DD,O-9 SCP NETWORK
S DDIO-16 SCP NETWORK
0 DDll-2 SEAT MEMORY STATUS LED
DRIVER REAR DOOR CONTROL
77 Pin Description
BAVERY POWER SUPPLY
LOGIC GROUND
SCP NETWORK
S RD10-16 SCP NE7WORK
MODULE
Active
GROUND
GROUND
GROUND
GROUND
GROUND
IMOMENTARY)
,CRANKINGl
GROUND
B-
2- 1800 HZ
2- ,800 HZ
GROUND iMOMENTARYl B+
Active
B-
GROUND
2- ,600 HZ
2- 1800 HZ
GROUND
Active
B+
(LED ONi
Inactive
Bt
B+
B+
Bc
B+
B+
B+
Inactive
B+
GROUND
B+
Inactive
Bt
GROUND
COMPONENTS
Component Connector I Type I Color Location I Access
BODY PROCESSOR
MODULE
DOOR CONTROL MODULE- DRIVER
DOOR CONTROL MODULE- DRIVER REAR
,NSTR”MENT
PACK
MEMORY SWITCHES
(DRIVER DOOR SWITCH PACKI
SEAT CONTROL MODULE - DRI”ER
SEAT CUSHlON HEATERS - DRIVER
SEAT HEATER SWITCH
(CENTER CONSOLE SWITCH PACK1
SEAT LUMBAR
SEAT MOTORS
GROUND
2- ,600 Hz
2 - ,600 Hz RELAYS
I RD,O-19 MODULE IDENTIFICAT,ON GROUND
/ RDll-5 MEMORY 1
I RD11~7 MODULE IDENTIFICATION
/ RDll-13 MEMORY SET
I RDll-15 MEMORY 3
I RD11~22 MEMORY 2
DRIVER SEAT CONTROL
v Pin Description
0 SM,-,D
0 SM1~2D
0 SMMD
0 SM,-40
0 SM,-SD
0 SM,-8D
0 SMI-7D
0 SMMD
I SM,-SD
I SMI-IOD
I SMI-IlD
I SM,-lZD
I SM,-732
I SMI-l4D
/ SMI-15D
I SMl-18D
MODULE
DRIVER SEAT SOUAB FORE, AFT RECLINE MOTOR SUPPLY
DRIVER SEAT SOUAB FORE, AFT RECLINE MOTOR SUPPLY
DRl”ER SEAT CUSHION RAlSE, LOWER FRONT MOTOR SUPPLY
DRIVER SEAT CUSHION RAISE, LOWER FRONT MOTOR SUPPLY
DRl”ER HEADREST RAlSE , LOWER MOTOR SUPPLY
DRIVER HEADREST RAlSE, LOWER MOTOR SUPPLY
DRIVER SEAT CUSHlON FORE /AFT MOTOR SUPPLY
DRIVER SEAT CUSHlON FORE /AFT MOTOR SUPPLY
DRIVER SEAT CUSHION FORE MOVEMENT REQUEST
DRIVER SEAT CUSHION AFT MOVEMENT REOUEST
DRIVER SEAT C”SH,ON LOWER REAR MOVEMENT REOUEST
DRIVER SEAT CUSHiON RAiSE REAR MOVEMENT REOUEST
DRIVER SEAT CUSHION RAISE FRONT MOVEMENT REOUEST
DRIVER SEAT CUSHION LOWER FRONT MOVEMENT REOUES,
DRIVER SEAT SOUAB AFT RECLINE MOVEMENT REOUEST
DRIVER SEAT SOUAB FORE RECLINE MOVEMENT REQUEST
0 SMCID DRIVER SEAT CUSHION RE*R, SOUAB RECLINE MOTOR POT REF. GROUND
0 SM2-2D DRIVER SEAT CUSHION FORE, AFT MOTOR POT. REFERENCE GROUND
0 SM2-SD DRIVER SEAT CUSHION REAR, SOUAB RECLINE MOTOR POT. REF. VOLTAGE
0 SM2-8D DRIVER SEAT CUSHION FRONT MOTOR POT. REFERENCE VOLTAGE
I SM2-8D DRIVER SEAT HEADREST MOTOR POTENTIOMETER FEEDBACK
1 SM2-9D DRl”ER SEAT CUSHlON FRONT MOTOR POTENTlOMETER FEEDBACK
I SMZ-1OD DRIVER SEAT CUSHION REAR MOTOR POTENTIOMETER FEEDBACK
I SMZ-l,D DRIVER SEAT SOUAB RECLINE MOTOR POTENTIOMETER FEEDBACK
I SMZ-12D DRIVER SEAT CUSHlON FORE, AFT MOTOR POTENTIOMETER FEEDBACK
0 SM2-l4D DRIVER SEAT HEADREST MOTOR POTENTIOMETER REFERENCE GROUND
0 SM2-l5D DRi”ER SEAT CUSHION FRONT MOTOR POTENTIOMETER REFERENCE GROUND
0 SM2-,813 DRl”ER SEAT C”SHlON FORE, A” MOTOR POT. REFERENCE VOLTAGE
0 SM2-l9D DRIVER SEAT HEADREST MOTOR POTENTIOMETER REFERENCE VOLTAGE
B+
GROUND
B+
B+
GROUND
GROUND
GROUND
GROUND
GROUND
PUMP-DRIVER
- DRIVER
SEAT SOUAB HEATERS - DRIVER
SWlTCH PACK - DRIVER SEAT
B+ HARNESS-TO-HARNESS CONNECTORS
Active
B+
B+
B+
El+
B+
B+
B+
B+
B+
B+
B+
B+
B+
B+
*+
B+
GROUND
GROUND
5”
,O”=“P,,V=DOWN
10”=UP,1”=DOWN
10V=“P,l”=DOWN
S”=FORE.ZV=AFT
2 V = FORE, 10 V = AFT
GROUND
GROUND
5”
5v
Inactive
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
FC,S,14-WAYAMPEEECIGREY
DDlO, 22.WAY FORD 2.8 TIMER, BLUE
DD, ,,22-WAY FORD 2.8 TIMER, BLACK
RDlO, 22.WAY FORD 2.8 TIMER, BLUE
RD, I, 22~WAY FORD 2.8 TMER , BLACK
FC24!48-WAY AMP MODULE PC9 SIGNAL, BLACK
FC25,24-WAY AMP MODULE PC9 SIGNAL, BLACK
DD, , IS-WAY MOS-29, YELLOW
Sk,,-D, ,&WAY FORD 2 8 TiMER i BLACK
SMP-D ,26-WAY FORD IDC, BLACK
SW-D, ,&WAY FORD 2 8 TIMER, BLACK
BULKHEAD, BEHIND GLOVE BOX
DOOR CASING, TRIM PANEL
DOOR CASING, TRIM PANEL
FASCIA
DOOR TRiM
PANEL
DRlVER SEAT, UNDER
SM7-D , SWAY MULTILOCK 070, YELLOW DRIVER SEAT
cc,, 16.WAY FORD IDC S.” , BLACK
SM10-D, O-WAY MULTILOCK 070 /YELLOW DRIVER SEAT
SMl~D, B-WAY MULTILOCK 070, GREY DRlVER SEAT, UNDER
SMG-D, B-WAY MULTlLOCK 070, YELLOW
SM, ,~D, B-WAY MULTlLOCK 070, WHlTE
SM,2-D, B-WAY MULTlLOCK 070, WHlTE
SM,B-D , S-WAY MULTiLOCK 070, YELLOW
349-D , J-WAY MULTILOCK 070, GREY DRIVER SEAT
SM%D, 18.WAY MULTlLOCK 040, BLACK DRIVER SEAT
Relay Case Color Connector I Color Location / Access
SEAT HEATER RELAY DRIVER BROWN SM14-D/BROWN FRONT SEAT RELAYS, UNDER SEAT
Connector
CA8
CA10
CA13
CA14
CA23
FC1
FC5
FC7
GROUNDS
Ground
CA25L
CA25R
CA26L
CA26R
CA33L
CABSL
ccx
Type / Color
*O-WAY MULTILOCK 070, WHITE
B-WAY MULTILOCK 070, YELLOW
S-WAY MULTlLOCK 070, WHITE
B-WAY MULTlLOCK 070, WHITE
I(1-WAY MULTILOCK 070, WHITE
W-WAY THROUGH PANEL CONNECTOR, BLACK
54.WAY THROUGH PANEL CONNECTOR/BLACK
2%WAY MULTILOCK 070, WHITE
Location
I Type
EYELET IPAIR) - PASSENGER SEAT GROUND STUD
EYELET IPAIR) - PASSENGER SEAT GROUND STUD
EYELET (PAIR, - DRIVER SEAT GROUND STUD
EYELET (PAIR, - DRIVER SEAT GROUND STUD
EYELET IPAIR, - RH ‘K POST GROUND SCREW
EYELET (PAIR) - LH ‘A’ POST GROUND SCREW
EYELET (PA,R) - RH FRONT BULKHEAD STUD, CABlN SIDE
Location
/ Access
DRlVER ‘I’ POST, DOOR HARNESS GAITER
DRIVER ‘A’ POST, DOOR HARNESS GAITER
DR,“ER ‘B,c’ POST, DOOR HARNESS GAITER
DRIVER ‘Bit’ POST, DOOR HARNESS GAITER
BELOW DRIVER SEAT
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
BELOW PASSENGER SlDE AIR “ENT, GLOVE BOX ASSEMBLY
BELOW DRIVER SIDE AIR VENT, COIN TRAY
ABOVE DIMMER MODULE, COIN TRAY
I SMB-1D
I SMB-2D
0 SM3-3D
0 SM3-4D
I SM3-5D
/ SM3-8D
I SM3-8D
S SM3-9D
S SM3-lOD
MODULE lDENTlFlCAT,ON
POWER GROUND
DRIVER SEAT RAISE, LOWER MOTOR SUPPLY
DRIVER SEAT RAISE, LOWER MOTOR SUPPLY
BATTERY POWER SUPPLY
DRIVER SEAT HEADREST RAISE MOVEMENT REQUEST
DRIVER SEAT HEADREST LOWER MOVEMENT REOUEST
SW NETWORK
SCP NETwORK
GROUND
GROUND
B+
B+
Bc
Bt
B+
(DRIVER)
GROUND
GROUND
GROUND
B+
GROUND
GROUND
INSTRUMENT
PACK
c7 Pin Description
S FC24-19 SCP NETWORK
S FC24-20 SCP NETwORK
C FC24-24 CAN NETWORK
C FC24-47 CAN NETWORK
Active
Inactive
NOTE: REFER TO THE APPENDIX AT THE REAR OF THIS BOOK FOR CAN AND SCP NETWORK MESSAGES.
The following symbols are used to represent values for Control Module Pin Out data:
I Input D Serial and encoded communications B+ Battery voltage KHz Frequency x 1000
0 output C CAN (Network) V Voltage (DC) MS Milliseconds
SG Signal Ground S SCP Network Hz Frequency MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS, RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997