Jaguar XJ 1998 - JagRepair.com

CONTROL MODULE PIN OUT INFORMATION
BODY PROCESSOR MODULE
Description
IGNlTlON SWITCHED GROUND
SEAT HEATER STATUS (LHD _ PASSENGER, RHD = DRIVER)
IGNITION SWITCHED GROUND
SEAT HEATER REQUEST ILHD = PASSENGER, RHD = DRIVER)
STARTER ENGAGE REQUEST
SEAT HEATER STATUS ILHD = DRIVER. RHD = PASSENGER)
BATTERY SUPPLY VOLTAGE
SEAT HEATER REQUEST (LHD _ DRIVER, RHD i PASSENGER)
Active
GROUND
GROUND
GROUND
GROUND
GROUND
GROUND
*+
GROVND
(MOMENTARY)
(CRANKING)
(MOMENTARY,
Inactive
B+
B+
B+
B+
B+
B+
St
B+
COMPONENTS
Component Connector / Type I Color Location I Access
BODY PROCESSOR MODVLE
FC15, ,4~WAYAMPEEEC,GREY
BULKHEAD, BEHIND GLOVE BOX
SEAT CUSHION HEATERS - DRlVER
SM%D, W’JAY MULTILOCK 070, YELLOW
DRIVER SEAT
SEAT CUSHION HEATERS-PASSENGER
SM7-P, 3-WAY MULTILOCK 070, YELLOW
PASSENGER SEAT
SEAT HEATER SWTCHES
CC,, 16.WAY FORD IDC S.U.! BLACK
CENTER CONSOLE SWlTCH PACK
(CENTER CONSOLE SWITCH PAW
SEAT SQUAB HEATERS - DRIVER
Smiled, B-WAY MULTILOCK 070, GREY
DRIVER SEAT
SEAT SQUAB HEATERS- PASSENGER
SMS-Pi 3-WAY MVLTILDCK 070, GREY
PASSENGER SEAT
RELAYS
Relay Case Color Connector / Color Location I Access
SEAT HEATER RELAY- DRIVER
SEATHEATERRELAY-PASSENGER
BROWN
BROWN
SMl4-D,BROWN
SMll~P, BROWN
FRONT SEAT RELAYS, UNDER SEAT
FRONT SEAT RELAYS, UNDER SEAT
HARNESS-TO-HARNESS CONNECTORS
Connector Type / Color Location I Access
CA23 l&WAY MULTlLOCK 070, WHITE BELOW DRIVER SEAT
CA27 ?&WAY MULTlLOCK 070, WHITE BELOW PASSENGER SEAT
FCI 54.WAY THROUGH PANEL CONNECTOR, BLACK BELOW PASSENGER SIDE AIR VENT, GLOVE BOX ASSEMBLY
FC5 54WAY THROUGH PANEL CONNECTOR, BLACK BELOW DRIVER SIDE AIR VENT, COIN TRAY
FC7 X-WAY MULTILOCK 070 /WHITE ABOVE DIMMER MODULE, COIN TRAY
GROUNDS
Ground Location I Type
CCBL
CA25L
CA26L
EYELET (PAIR) - RH FRONT BULKHEAD STUD, CABIN SIDE
EYELET (PAIR) - PASSENGER SEAT GROUND STUD
EYELET (PAIR, - DRIVER SEAT GROUND STUD
CONTROL MODULE PIN OUT INFORMATION (FOLD OUT PAGE)
4-
The following symbols are used to represent values for Control Module Pin Out data:
I Input D Serial and encoded communications
B+ Battery voltage KHz Frequency x 1000
0 output
C CAN (Network)
V Voltage (DC) MS Milliseconds
SG Signal Ground
S SCP Network Hz Frequency MV Millivolts
CAUTION: The information on this data page is furnished to aid the user in understanding circuit operation. THIS INFORMATION SHOULD BE USED FOR REFERENCE ONLY.
NOTE: The values listed are approximately those that can be expected at the control module connector pins with all circuit connections made and all
components connected and fitted. “Active” means a load is applied or a switch is ON; “Inactive” means a load is not applied or a switch is OFF.
REFER TO THE FRONT OF THE BOOK FOR ILLUSTRATIONS DETAILING THE LOCATION AND IDENTIFICATION OF COMPONENTS. RELAYS.
CONNECTORS, HARNESSES, GROUNDS, VEHICLE CONTROL MODULES AND CONTROL MODULE PINS.
DATE OF ISSUE: SEPTEMBER 1997