25.02.2015 Views

VOLUME I Multinational Maritime Tactical Instructions and Procedures

VOLUME I Multinational Maritime Tactical Instructions and Procedures

VOLUME I Multinational Maritime Tactical Instructions and Procedures

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

MTP 1(D), Vol. I<br />

(2) Radio Communication (omnidirectional).<br />

• Within 10 meters of fueling point, fueling rig or nearest point of aircraft vehicle or craft being<br />

fueled, or replenished, no transmissions at all from own or other ship are authorized.<br />

• Between 10 <strong>and</strong> 30 meters, transmissions are allowed from own <strong>and</strong> other ship up to 250 W per<br />

transmitter (no limit to the number of transmitter).<br />

• Above 30 meters, no restriction. Transmitters connected to a dummy load do not cause RADHAZ<br />

risks <strong>and</strong> are not restricted by the above precautions.<br />

6760 NOT RELEASABLE<br />

6761 ASW COMPENSATORY ALLOWANCES<br />

a. For any ASW engagement, air <strong>and</strong> surface units shall apply a compensatory allowance which<br />

minimizes the risk of that weapon inadvertently entering an area containing a friendly submarine.<br />

NOT RELEASABLE<br />

b. The weapon danger zone is based on the type of weapon, method of employment, run<br />

pattern, <strong>and</strong> estimated acquisition range. This danger zone is not intended to be the maximum<br />

possible weapon run, but an area which will protect the submarine from a properly operating<br />

weapon. Weapon danger parameters are derived from ASW weapon employment publications, <strong>and</strong><br />

may also be specified by the ASWC.<br />

c. Submarines shall remain clear of their area boundaries by at least their assessed navigation error<br />

<strong>and</strong> take appropriate precautions to prevent its own ASW weapons from endangering friendly submarines<br />

<strong>and</strong> surface units.<br />

d. Figure 6-10 illustrates compensatory allowances.<br />

6762 <strong>and</strong> 6763 NOT RELEASABLE<br />

6-100b CHANGE 2

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!