You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
100<br />
Getting Started with CreativeStudio<br />
* Total Width - is the width of all the repeats (measured from either the<br />
start/end points or measured from the outer edges of the patterns - see<br />
below).<br />
* Total Height - is the height of all the rows (measured from either the<br />
start/end points or measured from the outer edges of the patterns - see<br />
below).<br />
* Start End Controlled 125 (ON / OFF) means the total width/height is<br />
measured between the start / end points rather than the outer edges of the<br />
patterns.<br />
* Spacing (Horiz / Vert) is the distance between patterns. Positive numbers<br />
spread the patterns further apart and negative numbers bring them closer<br />
together.<br />
* Square Up Quilt Angle - is the number of degrees of rotation applied to the<br />
pattern group. This applies to patterns grouped together.<br />
* Select Between blocks - what to do between each pattern.<br />
- BobbinPullUp treats each pattern individually and will pause to allow the<br />
bobbin thread to be pulled up and trimmed.<br />
- Connect Start/End treats the patterns as a group, stitching them in a<br />
continuous path, joining the end of one pattern to the start of the next.<br />
Reference Point Location 50<br />
Reference Point Selection is specific to the pattern, BEFORE the Square Up angle<br />
rotates the pattern.<br />
* Reference Point Position is how CS knows where to put the pattern image. It will<br />
appear in the preview area as a small blue circle with an arrow.<br />
* Offset from Point - is the distance (H and V) between the clicked reference point<br />
and what the pattern will use as a reference point.
Change language