Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Quilting the Quilt - Which CS Feature To use<br />
Phase 1 - Basting<br />
Stitch in the Ditch using Point_to_Point-Line<br />
Tip: P2P-Line is an accurate way to follow a seam. When the seam<br />
has a curve in it, the P2P click points can be very close together,<br />
following the curve of the seam. If it is straight, the click points can<br />
be further apart.<br />
5. Click on Start_Quilting and the sewing head will move to the Start of the<br />
pattern. CS will prompt for pulling up the bobbin thread.<br />
Tip: P2P-Line has its own motor speed control (found in the<br />
configuration form). It is a good idea to stitch P2P-Line very slowly.<br />
the default value is 10% motor speed but this can be increased or<br />
decreated while stitching, using the keypad. SPI and Tie-off setting<br />
are inherited from the project.<br />
6. Press OK when ready to quilt,<br />
7. At the end of the quilting sequence, you will be prompted to pull up the bobbin<br />
thread and click OK. It doesn't matter how the bobbin thread is pulled up, secured or<br />
trimmed. Just be sure to click OK because it completes this process.<br />
Copyright © 2009 <strong>Gammill</strong>, Inc. | All Rights Reserved<br />
93
Change language