download PDF - Gammill

Planning the Quilting
Quilt Pattern Setup and Edit
Setup Mode
* Click Open to choose this pattern. CS is ready to choose more patterns so repeat
the file selection process as needed. When done, click Cancel to exit.
If you change your mind, and decide not to use a pattern that has been selected, just
remove it by clicking on the Delete Pattern icon.
* Save the project.
Step 2: Measure
CS provides a Measure function which can be used throughout the entire quilting
process. Stitching a single pattern in a boundary does not require the Measure
function but most other features do use it. Click the icon to begin the measure
process.
CS prompts with the "Perform measurements" dialog box. Move the stitcher to the
beginning of the line and press OK. Move the stitcher to the end of the line and press
OK again.
Copyright © 2009 Gammill, Inc. | All Rights Reserved
71