download PDF - Gammill

166
Getting Started with CreativeStudio
Start - starts the stitching process, and STOP ends it.
Additional Functions: These functions (light blue buttons) are initiated by using a 2-button
sequence; press and hold the Shift button and then press the second button.
Flip Chan Lock - Changes the current angle.
* If Radiating Lines is not checked, this will change the current angle to whatever the Flip
Angle is set at. To flip the angle, press and hold the shift button on the keypad, and
press the Chan Lock button. To flip it back again, repeat the 2-button sequence.
* If Radiating Lines is checked, CS increases the current angle by the number of degrees
shown in Flip Angle. To increase the angle, press and hold the shift button on the
keypad, and press the Chan Lock button. Repeat to increase it again. It will go up to 90
degrees and return back to 0 degrees.
Shift - used to display additional functions (light blue buttons) and to execute them.
Change to Need Pos - is used to 'check' (or choose) the Needle Position option, making the
Lower Left button change to 'Needle Position'. Press and hold the Shift button and
press Change To Need Pos button. Repeat the 2-button sequence to return to Single
Stitch.
Start - starts the stitching process, and STOP ends it.
Exit - To exit regulated mode, press and hold the Shift button and press the Exit button.
Using the mouse & screen works too.
3. Press Start on keypad when ready to sew and Stop on keypad to stop. Dark blue buttons
mean the stitcher is running. Notice that the two buttons on the left have changed in
meaning.
Inc SPI means Increase the Stitches per Inch.
Dec SPI is decrease stitches per inch.
4. Press Shift and Exit on keypad when ready to exit regulated mode.
Copyright © 2009 Gammill, Inc. | All Rights Reserved
Statler Stitcher® is a registered trademark of Gammill, Inc.
CreativeStudio is a trademark of Gammill, Inc