download PDF - Gammill

182
Getting Started with CreativeStudio
Feature: Edge To Edge - Continue
Assumptions: The first section (or more) is done, the registration points have been marked
and the quilt has been rolled.
9. Click EdgeToEdge_Continue
10. Mark the boundary as prompted: CS prompts for left registration mark and right
registration mark,
11. Check the screen and adjust if needed.
12. Click Quilt. The first row of the new section now begins.
At the end of the row, CS stops, prompts for bobbin pull-up, Click OK.
Repeat each row until the entire current section is done.
CS will again prompt for marking registration points.
Roll the quilt.
Repeat steps 9 - 12 until the last section - when bottom edge of the quilt
makes its way up to the current quiltable space.
13. Last Section adjustments are often necessary so the last time you roll the quilt,
the prompts are a little different.
Save the project 60
.
14. Click Quilt The machine moves to the start of the pattern, takes a
single stitch and prompts you to pull up the bobbin, so do that. Press OK on the
keypad when ready. The first row of the new section now begins.
15. At the end of the last row, CS stops and prompts you to cut the bobbin thread
and click OK.
Copyright © 2009 Gammill, Inc. | All Rights Reserved
Statler Stitcher® is a registered trademark of Gammill, Inc.
CreativeStudio is a trademark of Gammill, Inc