Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
140<br />
Getting Started with CreativeStudio<br />
6. At the end of the row, CS stops and prompts you to cut the bobbin thread. It<br />
doesn't matter how the bobbin thread is pulled up, secured or trimmed. Just be sure<br />
to click OK because it completes this process.<br />
6A. IF you have room for another row the machine will move to the<br />
beginning of the next row, take a stitch, prompt for Bobbin pull-up and click<br />
OK to quilt the next row. Repeat these steps until all the rows for the current<br />
section are complete.<br />
7. When CS finishes the last row that fits, you will be prompted to cut the bobbin<br />
thread and mark the two registration points. Here is what will happen:<br />
* CS finishes the last row that will fit. CS prompts you to cut the bobbin thread, so<br />
do that. Click OK to complete the end-of-row process.<br />
* CS prompts you to click OK when ready to mark the Right registration point. Click<br />
OK and the stitcher moves to the first registration point. Place a pin in Registration<br />
Point #1 (where the needle would enter the fabric).<br />
* CS prompts you to click OK when ready to mark the Left registration point. Click<br />
OK and the stitcher moves to the second registration point. Place a pin in<br />
Registration Point #2 (where the needle would enter the fabric). Click OK to<br />
complete the process.<br />
Save the project 60<br />
.<br />
8. Roll the quilt (baste the sides, check the bobbin, etc.)<br />
Now finish the quilt by using the Feature: Edge To Edge Continue
Change language