download PDF - Gammill

158
Getting Started with CreativeStudio
The Configuration Form has three tabs; User Settable (sp?), Stitcher Settings (which
controls the stitcher) and Galil Settings (which control the motors). DO NOT make
changes to either the Stitcher Settings or the Galil Settings without the guidance of
the Statler Tech Support Team.
The Stitcher Settings:
Left Column contains the following default values–
Speed – This is the default motor speed, in percentage. A value of 50 means 50%
of the motor capacity.
P2P Line Speed - This is the default motor speed when using the P2P Line
feature.
SPI – is the initial setting for stitches per inch (SPI)
Min SPI – is the minimum stitches per inch allowed by CS.
Tieoffs – Check means CS will do tieoff stitches at the beginning and end of each
stitching line.
Tieoff Stitches – This is the number of stitches taken by the tieoff feature.
Tieoff SPI – This is the size of the stitches taken by the tieoff feature.
Margins – This is the default margin size in inches.
Tip: Tie-off stitches will be more secure if the TieSPI is not evenly
divisible by the SPI. This means TieSPI divided by SPI should not be
a whole number. Example:
If SPI = 10, TieSPI should not be 10, 20 or 30. It can be 21, 22, 23 ... 29,
31, 32, etc.
If SPI = 12, Tie SPI should not be 12, 24 or 36. It can be 25, 26, 27... 35,
37, 38, etc.