Manual - AEQ International

2.1.1.7. Fader.100mm. fader. The fader travel is printed with 11 bands, the maximum output level +22dBcorresponding to the last, and the third band from above to +0dB or nominal operating level.Both of these marks are differentiated in size from the rest.+22dB+0dBDetail of 100mm fader calibrationThe response mode of the fader is logarithmic, producing great attenuation of the level at thebottom of the fader travel and less adjustment at the top.The bottom position of the fader travel triggers gain -∞dB or absence of signal.2.1.2. Control and monitoring section.The control and monitoring section (C&M) of the control surface is located to the right. Thissection enables the overall management of the signals on the system, including routing andcontrol processes, as well as monitoring of the signals used in developing the final program, bymeans of the VU-Meters, and CUE control.This control and monitoring section is divided into four main areas:• Control VU meters: allows you to monitor visually the level of the audio signals fromthe master output and the CUE bus (or the control monitoring bus, when there are nochannels sent to CUE).• Programmable keys: dedicated buttons with special functions defined through theconfiguration software.• Main screen: it displays the internal menus. This section also incorporates contextualkeys and encoders.• Studio, Control and Talk-back monitoring: where you can manage the audio signalssent to the headphones and speakers, for the control room and the studio room, as wellas the talk-back functions for the intercom for both areas.AEQ CAPITOLUltra-compact digital audio mixer11