Manual - AEQ International

The lower part of the “Programmable Keys” submenu will show the associated options for“Multiplex” type keys, when this configuration mode is selected. In order to be able to configurethe programmable key (or edit a previously created configuration), you have to press the “Edit”button, to active and allows you to assign to that key one of the 8 available “MPX” buses:These keys works as follows: when you press and keep pressed the key you can activate therouting toward the associated “MPX” bus of any audio input channel assigned to a fader at thatmoment. To activate that routing, you just have to press the “SELECT” key of the desiredchannel/s (the associated LED turns on) while programmable key is pressed; by pressing againthe “SELECT” key that routing is deactivated (the associated LED turns off). When you stoppressing the programmable key, the activated “SELECT” keys turns off and they recover itsoriginal function.4.3.2.6. Configuration of “Cue Reset” programmable key.“Cue Reset” option allows you to configure a programmable key as a key to disconnectimmediately all the signal sendings to the CUE bus at that moment. A key set to this function isassigned with a dedicated icon.The lower part of the “Programmable Keys” submenu will show no options when thisconfiguration mode is selected.The activation of this “Cue Reset” function will have the following result in AEQ CAPITOLcontrol surface: when the key is pressed, all the circuits or channels being sent to the CUE busof the mixer will be disconnected and the LEDs of all the “CUE” keys that may be active will beturned off.4.3.2.7. Configuration of “Orders” programmable keys.Programmable keys that are set to “Orders” enables you to send the orders microphone to theselected output channel. A key set to this function is assigned with a dedicated icon.The lower part of the “Programmable Keys” submenu will allow you to configure the outputassociated to the programmable key. In order to be able to configure the programmable key (oredit a previously configured key), you have to press the “Edit” button, to active and allows youto assign to that key any of the outputs defined in the system.AEQ CAPITOLUltra-compact digital audio mixer83