Manual - AEQ International

More documents

Recommendations

Info

“ANALOG IN 1-4” connectorPin Signal Pin Signal1 IN1+ 9 IN1-2 GND 10 GND3 IN2+ 11 IN2-4 GND 12 GND5 IN3+ 13 IN3-6 GND 14 GND7 IN4+ 15 IN4-8 GND“ANALOG IN 5-8” connectorPin Signal Pin Signal1 IN5+ 9 IN5-2 GND 10 GND3 IN6+ 11 IN6-4 GND 12 GND5 IN7+ 13 IN7-6 GND 14 GND7 IN8+ 15 IN8-8 GND“ANALOG IN 9-12” connectorPin Signal Pin Signal1 IN9+ 9 IN9-2 GND 10 GND3 IN10+ 11 IN10-4 GND 12 GND5 IN11+ 13 IN11-6 GND 14 GND7 IN12+ 15 IN12-8 GNDIn order to make installation process easier, AEQ offers specific pre-fabricated cable kits forAEQ CAPITOL audio input/output, both analog and digital, as well as studio headphones: FRCAB INP, consisting in a male DB15 connector soldered to 4 balanced and shielded 6 meterslong paired cables with no connectors at the other end, for 4 inputs or outputs. For moreinformation please check chapter 2.2.6 of this manual.AEQ can upon request provide fully finished cables and in special lengths. For more informationplease refer to AEQ sales department or authorised distributors.All 12 mono inputs can be configured, pair by pair, as 6 stereo inputs, depending on theparticular application or installation, using the cofiguration software. For more informationplease check chapter “4.2.3. I/O Configuration submenu” of this manual.2.2.3.5. Analog outputs.AEQ CAPITOL includes 8 mono line-level outputs, electronically balanced, available through 2female DB15 connectors identified as “ANALOG OUT 1-4” and “ANALOG OUT 5-8”.Analog Outputs (SUB-D female, 15 pins):AEQ CAPITOLUltra-compact digital audio mixer30
“ANALOG OUT 1-4” connectorPin Signal Pin Signal1 OUT1+ 9 OUT1-2 GND 10 GND3 OUT2+ 11 OUT2-4 GND 12 GND5 OUT3+ 13 OUT3-6 GND 14 GND7 OUT4+ 15 OUT4-8 GND“ANALOG OUT 5-8” connectorPin Signal Pin Signal1 OUT5+ 9 OUT5-2 GND 10 GND3 OUT6+ 11 OUT6-4 GND 12 GND5 OUT7+ 13 OUT7-6 GND 14 GND7 OUT8+ 15 OUT8-8 GNDIn order to make installation process easier, AEQ offers specific pre-fabricated cable kits forAEQ CAPITOL audio input/output, both analog and digital, as well as studio headphones: FRCAB INP, consisting in a male DB15 connector soldered to 4 balanced and shielded 6 meterslong paired cables with no connectors at the other end, for 4 inputs or outputs. For moreinformation please check chapter 2.2.6 of this manual.AEQ can upon request provide fully finished cables and in special lengths. For more informationplease refer to AEQ sales department or authorised distributors.All 8 mono outputs can be configured, pair by pair, as 4 stereo outputs, depending on theparticular application or installation, using the cofiguration software. For more informationplease check chapter “4.2.3. I/O Configuration submenu” of this manual.2.2.3.6. MIC/LINE inputs.AEQ CAPITOL includes 4 mono microphone/line inputs, available through 4 XLR femaleconnectors identified as “MIC/LIN-1”, “MIC/LIN-2”, “MIC/LIN-3” and “MIC/LIN-4”.XLR - Female 3p. Balanced connection.Pin 1 GNDPin 2 Input +Pin 3 Input -All of them include independent, internally accessible programming jumpers to select operationas microphone or line input, and also activation/deactivation of the +48V Phantom power. Bydefault, these inputs are configured for dynamic microphones without the need for Phantompower.- Programming inputs as line level or Phantom-powered Microphone inputs.Start by following the steps detailed at chapter 2.2.3.1 (it’s VERY IMPORTANT to turnfirst the equipment off and disconnect the power supply cable). Then, at the 2“MIC/LINE INPUTS AND PHANTOM POWER PROGRAMMING ZONES”, you canactivate individually the Phantom feed of each input or change from microphone level toline level as shown in the following images:AEQ CAPITOLUltra-compact digital audio mixer31
Page 5: Its Ethernet port enables the local
Page 8: In addition to the signals on chann
Page 12 and 13: VU metersPROGRAMMABLEKEYSMAINSCREEN
Page 14 and 15: At most, the last line will have fo
Page 16 and 17: • The three rotary encoders, from
Page 18 and 19: 2.1.3. Wrist- rest and side trims.A
Page 20 and 21: 2.2.1. Power supply.The power suppl
Page 22 and 23: • Maximum power: 100mW at 40 ° C
Page 24 and 25: 2.2.2.3. Control and studio monitor
Page 26 and 27: - Opening the unit.It’s VERY IMPO
Page 28 and 29: Digital input 4 Digital input 3 Dig
Page 32 and 33: MIC/LINE input 4 MIC/LINE input 3 M
Page 34 and 35: 2.2.4.2. CA33 telephone hybrid opti
Page 36 and 37: 3. DESCRIPTION OF THE INTERNAL MENU
Page 38 and 39: • “CHRONO”: enables you to co
Page 41 and 42: • “BACK”: pressing this key a
Page 43 and 44: 3.4.3. “SELECT“ menu.This menu
Page 45 and 46: The “Compressor / Limiter” func
Page 47 and 48: In addition, the threshold must be
Page 49 and 50: • In mic/line channels, indicatio
Page 51 and 52: • Indication of audio signal type
Page 53 and 54: Only the users defined as administr
Page 55 and 56: There are two distinct areas in thi
Page 57 and 58: The “Unlock” button allows you
Page 59 and 60: The lower part of the “User Confi
Page 61 and 62: 4.2.1. “Board Configuration” su
Page 63 and 64: o“TH02”: GPI to accept the part
Page 65 and 66: The mixer bus configuration table h
Page 67 and 68: 4.2.3.1. Advanced configuration of
Page 69 and 70: • “Mono”: allows you to defin
Page 71 and 72: 4.2.4.1. “Studio Room Section“.
Page 73 and 74: 4.3. “Programmable Configuration
Page 75 and 76: 4.3.2. “Programmable Keys” subm
Page 77 and 78: • “Latch Mode”: allows you to
Page 79 and 80: 4.3.2.4. Configuration of “Codec
Page 81 and 82:
• “On Air GPI”: selects and c
Page 83 and 84:
The lower part of the “Programmab
Page 85 and 86:
The three buttons at the bottom of
Page 87 and 88:
Allows you to scroll to the top of
Page 89 and 90:
• “ATTACK TIME”: this is the
Page 91 and 92:
4.3.4.4. Advanced configuration of
Page 93 and 94:
The available options in the snapsh
Page 95 and 96:
From left to right and from top to
Page 97 and 98:
4.4. “Firmware Upgrade” menu.Th
Page 99 and 100:
In case you select an AFU file that
Page 101 and 102:
5. A.E.Q. GUARANTEE.AEQ warrants th
show all

Manual - AEQ International

Create successful ePaper yourself

Delete template?

Save as template?