Manual - AEQ International

• “CHRONO”: enables you to configure and activate the chronometer option. The formaton screen is HOURS:MINUTES:SECONDS.The “START” contextual key initiates the chronometer, the “STOP” key (the same keythat changes its function) stops it, and the “RESET” key re-establishes the initial zerovalue (even when the chronometer is launched). The “BACK” key allows you to returnto the previous screen (it also stops the chronometer and re-establishes the initial zerovalue).3.2. “LOGIN/LOGOUT“ menu.This menu allows AEQ CAPITOL users/operators to register in the system, so that theequipment recognizes their user level by the associated password, and assigns them an accesslevel for subsequent operation in the different console submenus.AEQ CAPITOL enables up to 4 different user levels, each with its associated profiles andpasswords:• LEVEL 0: users with no associated password. You can access to this level by pressingthe “LOGOU” contextual key in the initial menu (that key changes to “LOGIN”). Theoperation is limited to raising and lowering faders, activate/deactivate the 4 routing keysand the CUE key of each channel, activate/deactivate channels (“CHANNEL ON/OFF”)and use the programmable keys and monitoring section. The “SELECT” key of eachchannel is not active and neither the options visible on the last line of the main menu(“CLOCK”, “MEMORY” and “MENU”); the “LOGIN” option is available in order to changeuser.• LEVEL 1: these users are defined in the configuration software with “Basic” accesslevel (see section 4.1.2 in this manual). In the initial screen, up on the right, theindication “BASIC” is shown to identify this level. These users may perform the sameactions as the level 0 users, and can also activate equalizers and filters, modify audioinput channels gains and modify the signal present in a certain channel. They can’tmodify phase and balance, activate dynamics processes or modify the routing. Only the“LOGOU” option is available in last line of the main menu in order to return to level 0(and then, be able to change user by means of “LOGIN” option).• LEVEL 2: these users are defined in the configuration software with “Advanced” accesslevel (see section 4.1.2 in this manual). In the initial screen, up on the right, theindication “ADVAN” is shown to identify this level. These users may perform the sameactions as the level 1 users, as well as all the additional operation, configuration andcontrol options that AEQ CAPITOL control surface and its associated internal menuoffers, except the change of the IP address of the “LAN” network port present in therear panel of the unit.• LEVEL 3: these users are defined in the configuration software with “Administrator”access level (see section 4.1.2 in this manual). In the initial screen, up on the right, theindication “ADMIN” is shown to identify this level. This is the highest level in the system,reserved for administrators. It enables full access to all the equipment menus andconfiguration options (including the change of the IP address of the network port of theunit), and, in addition, is the only level enable to access to the configuration software.The same password is used in this menu integrated into the control surface and inremote configuration software.AEQ CAPITOLUltra-compact digital audio mixer38