Manual - AEQ International

o“HP/SOURCE“:it controls the audio level for the physical output for the controlheadphones. To decrease the level turn the encoder to the left. To increase thelevel turn the encoder to the right. This encoder can also be used to select thesignal to monitor associated with the key “SEL”: press to access a list ofsignals, and turn the encoder to move up or down in the list of signals; pushingthe encoder a second time confirms the selection of the highlighted signal.o“CUE“:it controls the audio level of the CUE speakers .To decrease the levelturn the encoder to the left. To increase the level, turn the encoder to the right.• The four keys under the display allows to select the signal to monitor on controlspeakers and headset, from left to right:oooo“PROG“: allows you to monitor the audio signal Program.“AUD“: allows you to monitor the audio signal Audition.“SEL“: allows you to monitor any signal of the console previously selected bymeans of “HP/SOURCE“ encoder.“CUE“: allows you to monitor the audio signal present on the CUE bus.These four keys can have two working modes that are selected from the ConfigurationSoftware (see section 4.2.4 of this manual):oo“Mixer”: each key pressed adds the signal to be monitored to the summing bus.“Exclusive”: each key pressed connects the signal to the summing bus anddisconnects any signal previously selected.In case there are no channels sent to CUE, the signal or signals selected in this sectionwill be shown in the rigth control VU meter (see section 2.1.2.1 of this manual).2.1.2.5. Studio room monitoring section.Located in the lower left corner of the AEQ CAPITOL control surface are a two-coloured display,three rotary encoders and four keys (one of them, “SEL”, a short-cut key).• In the two-coloured OLED display are shown the output levels for the studio monitoringsignals and the selected sources in each case, for studio headset, studio speakers andtalkback.AEQ CAPITOLUltra-compact digital audio mixer15